How To Install

Follow the instructions below to get the best looking paddle in your area. Well, unless others around you also got Stinky Dink wraps and followed these instructions. In that case just be better then them at pickleball.

Step 1

Clean Paddle

Use a damp rag or paper towel and wipe any debris or residue off the edge guard. Be sure to dry it off as well before moving on to next step.

Step 2

Find Center Of Wrap

Locate the center of the wrap. Most Stinky Dink wraps have a subtle centerline already marked for you. If you can’t find it simply fold the wrap in half to locate your centerline (this will not effect your wrap installation)

Step 3

Peel Backing

Peel and remove the paper backing away from the centerline you just located. About an inch or 2 on either side of the centerline.

Step 4

Place Wrap

Align centerline of wrap in the middle of the top edge of paddle. Secure it in place making sure it’s even on both sides of edge guard. (Pro tip: hold the paddle between your legs for this step)

Step 5

Apply Wrap To One Side

Peel the backing from one side of the wrap and apply it evenly down paddle. In order to get wrap spaced evenly side to side close one eye while holding wrap taught and menuever paddle underneath it until it’s where you want it then let wrap drop onto edge. Continue this the whole way down to the handle.

Step 6

Trim Excess

Figure out where you want your wrap to end and trim it with a scissors.

step 7

Repeat

Repeat steps 5 and 6 on the other side of your paddle

Step 8

Smooth edges

Smooth the wrap around the edges of your paddle. (Pro tip: use a hairdryer or heat gun to soften the wrap while you smooth out the edges while NOT burning yourself)

Step 9

Bask In Your Accomplishment

Now go prove to everyone how much better you are with your new sweet sweet paddle!